Powder-metallurgy tool steel
CPM 3V tool steel
CPM 3V is a powder-metallurgy tool steel. Trade name CPM 3V. Finer carbide distribution than conventionally melted material. Bought on trade name and condition. Typically supplied as round bar, flat bar, plate.
- Delivery conditions
- soft annealed
- Also known as
- PM koldarbejde, CPM 3V
Designations
- EN standard
- PM koldarbejde
- Group
- Tool steel
What it is used for
Demanding tooling where conventionally melted material does not hold up, in CPM 3V.
Limits
Trade name and condition on the PO. We write the W.Nr. or brand the certificate can carry.
Delivery
We source CPM 3V from European mill partners as round bar, flat bar, plate, cut to your dimensions and ship the certificate with the material. Typical condition: soft annealed. Standard: PM koldarbejde. From one sawn piece of the block to a series of parts — with no minimum charge.
Certificates and documentation
CPM 3V can be supplied with a material certificate to EN 10204, depending on producer, dimension and the requirements specified for the delivery. Tool steel is bought on W.Nr. and condition, and we write the number on the paper that the mill can carry — not a trade name the certificate does not cover. If a specific delivery hardness is to be documented, it must be on the order. EN 10204 3.1 can be supplied on a wide range of our materials.
Dimension programme
| Form | Range | Note |
|---|---|---|
| Round bar | Ø20–250 mm | Soft annealed or pre-hardened. Bought by W.Nr. |
| Flat bar | Flat cut to order | Typically mould and cold-work flat. |
| Plate | To order | Not structural plate. |
The range is a delivery programme, not a stock statement. Length is cut to your drawing.
Read more
Send your enquiry
State grade, dimensions and quantity — or attach a drawing. We reply with a quote.