Cold-work tool steel
DPM450 tool steel
DPM450 is a cold-work tool steel. Bought on W.Nr. and condition — typically soft annealed, ready for grinding and hardening. Typically supplied as round bar, flat bar, square bar.
- Delivery conditions
- soft annealed
- Also known as
- dpm450, powder
Designations
- EN standard
- DPM450
- Group
- Tool steel
What it is used for
Punches, dies and cold tooling in DPM450.
Limits
Bought on W.Nr. and condition. PM variants when conventionally melted D2/1.2379 does not hold up.
Delivery
We source DPM450 from European mill partners as round bar, flat bar, square bar, cut to your dimensions and ship the certificate with the material. Typical condition: soft annealed. From one sawn piece of the block to a series of parts — with no minimum charge.
Certificates and documentation
DPM450 can be supplied with a material certificate to EN 10204, depending on producer, dimension and the requirements specified for the delivery. Tool steel is bought on W.Nr. and condition, and we write the number on the paper that the mill can carry — not a trade name the certificate does not cover. If a specific delivery hardness is to be documented, it must be on the order. EN 10204 3.1 can be supplied on a wide range of our materials.
Dimension programme
| Form | Range | Note |
|---|---|---|
| Round bar | Ø20–250 mm | Soft annealed or pre-hardened. Bought by W.Nr. |
| Flat bar | Flat cut to order | Typically mould and cold-work flat. |
The range is a delivery programme, not a stock statement. Length is cut to your drawing.
Read more
Send your enquiry
State grade, dimensions and quantity — or attach a drawing. We reply with a quote.